93C86 Datasheet, 93C86 8kbyte Serial EEPROM Datasheet, buy 93C 93c86 EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for 93c86 EEPROM. Kbit, 8-Kbit, 4-Kbit, 2-Kbit and 1-Kbit. (8-bit or bit wide) MICROWIREâ„¢ serial access EEPROM. Datasheet – production data. PDIP8 (BN).

Author: Kitaxe JoJogrel
Country: South Africa
Language: English (Spanish)
Genre: Health and Food
Published (Last): 18 August 2013
Pages: 244
PDF File Size: 12.61 Mb
ePub File Size: 8.6 Mb
ISBN: 961-1-30905-955-1
Downloads: 16653
Price: Free* [*Free Regsitration Required]
Uploader: Moogulrajas

CLK can be stopped anywhere in the transmission. The READ instruction outputs the serial data of the. When 938c6 is connected to. I CC write Write current. I CC read Read current.

All parameters apply over the specified. BUSY status during a programming operation. Data input setup time.

Microwire is a registered trademark of National Semiconductor. Write datzsheet by polling the DO pin; DO low indicates. DO at logical “0” indicates that program. Mold Draft Angle Bottom. Low level input voltage. The Microchip Technology Inc. These clock cycles are. Low power CMOS technology. Dimensions D and E1 do not include mold flash or protrusions. Low level output voltage. DO at logical “1” indicates that.


Chip select low time. However, with this datasueet it is possible.

Once the EWEN instruction is executed, program. After power-up, the device is automatically in the.

The higher the current sourcing capability datasheet. PE pin allows the user to write protect the entire. Data output delay time. This pin allows the user to enable or disable the ability. It is possible to connect the Data In and Data Out pins. The entire 93XX Series is. Note 2 Note 3. Advanced CMOS technology makes. CS is brought low. T SV is relative to CS.

8K/16K 5.0V Microwire Serial EEPROM

Datasgeet modes of operation are inhibited when V CC is below. Clocking of the CLK. High level input voltage. Sequential read is possible when.

93C86 Datasheet(PDF) – Microchip Technology

On those devices, programming is always enabled. Therefore, an EWEN instruction must be. This gives the controlling master. CLK pin is not necessary after the device has entered.


The status signal is not available on DO, if CS is held. Mold Draft Angle Top.

Ambient temperature with power applied The Serial Clock is used to synchronize the communi. The WRAL command does include an. Word-selectable devices such as. If CS is low, the internal. Stresses above those listed under “Maximum ratings” may cause permanent datasheett to the device. CLK cycles are not required during the self-timed.